Triminator Air Hydraulic Rosin Foot Pump. 10,000 PSI, BVA Built

What the Air Hydraulic Pump Changes on a Press The pump is what turns a press from a two handed job into a one footed one. Both hands come free for the bag and the parchment. Pressure then moves while you are watching the plate rather than while you are looking at a lever. Output reaches ten thousand PSI when the air supply is at a hundred PSI. Control runs through a two stage mechanism with an internal relief valve built in. That gives pump, hold and release all on the pedal. Pressure can be brought up in stages and held at a chosen point rather than jumping to maximum. Anyone who has worked a hand pump through a long session will recognise what is being removed here. The air inlet is a quarter inch NPT fitting and the oil port is three eighths inch NPT. It fits every Triminator TRP rosin press. Sizing a Compressor Before This Reaches the Rosin Press The requirement is strict, and it is the thing to settle first. The pump wants a minimum of five CFM at a hundred to a hundred and twenty PSI working pressure. That is the figure at pressure, not the optimistic number printed on the side of a small compressor at zero PSI. An undersized compressor makes this pump slower than pumping by hand. It is a costly point to ignore. Check the compressor plate for its delivery at a hundred PSI and compare. Duty cycle matters as much as flow, because a pancake compressor that meets the figure briefly will spend a pressing session recovering. The pump itself measures roughly twenty-eight by sixteen by fourteen inches and weighs about twenty-five pounds. It sits on the floor beside the press rather than on the bench. Keep the air line out of the walking route. Key Features Output: Ten thousand PSI when the air supply sits at a hundred PSI Built by: BVA, supplied under the Triminator part number Control: Pump, hold and release, all from the foot pedal Mechanism: Two stage release with an internal relief valve Hands free: Both hands stay on the bag and the parchment Air requirement: A minimum of five CFM at a hundred to a hundred and twenty PSI Compressor sizing: An undersized compressor runs slower than a hand pump Air inlet: Quarter inch NPT Oil port: Three eighths inch NPT Fits: Every Triminator TRP rosin press Technical Specifications Specification Value SKU 46-06-109800 Brand Triminator Pump manufacturer BVA Type Air over hydraulic foot pump Maximum output 10,000 PSI at 100 PSI air Air requirement Minimum 5 CFM at 100 to 120 PSI Control Foot pedal, with pump, hold and release Mechanism 2-stage release with internal relief valve Air inlet 1/4 in NPT Oil port 3/8 in NPT Compatibility All Triminator TRP rosin presses Dimensions About 28 x 16 x 14 in Weight About 25 lb