Replacement Straight Blade for DL Elite Trimmer. Single 16 in Cutting Blade

Elite Trimmer Replacement Blade for the DL Wholesale Stand-Up Trimmer The Elite stand-up trimmer cuts with one long straight blade turning just below its grate, and this is that blade. It measures 16 in end to end, 0.5 in across and 0.05 in thick. A widened center section carries the mounting hole that fits the drive hub. Each package holds 1 blade and weighs about 0.5 lb. Turning under the grate, the bar clips any leaf the rubber fingers push through the openings. Flower stays on top while the trim falls into the catch bag below. The blade is made for the DL Wholesale Elite trimmer, part number 777141. That machine pairs an aluminum bowl with a tilting top, so finished buds pour out in one motion. One blade comes installed on a new Elite, and this part replaces it. A sharp bar clips leaf cleanly instead of tearing it. Keeping a spare in the drawer means a dull edge never slows a harvest down. The catch bag hangs under the stand, so every clipping lands in one place. Fitting a Straight Trimmer Blade on the Elite Unplug the trimmer before touching anything inside the bowl. Tilt the top to reach the cutting area and lift away the grate. Hold the old blade steady and remove the fastener at the center hub. Lift the blade off and wipe resin and trim from the hub and the shaft. Seat the new blade with its center hole on the drive and refit the fastener firmly. Spin the blade slowly by hand to make sure it clears the bowl and grate all the way around. Refit the grate and lower the top back into its running position. Run a small test batch to check that leaf is clipping cleanly. Handle the blade by its center section, since the edges are sharp. Wear cut-resistant gloves whenever the bowl is open. Clean the blade after each session so resin does not build up along the edge. A buildup of sticky residue drags the cut and leaves ragged leaf. Store the spare flat in its packaging, away from tools that could nick it. A clean, true blade keeps the trim even from the first bud to the last. Key Features Single Straight Blade: One long cutting bar spans the bowl to clip leaf on every rotation. Center Mount: A widened center section with a mounting hole seats on the drive hub. Elite Fit: Made for the DL Wholesale Elite stand-up trimmer, part 777141. Slim Profile: A thin bar spins close under the grate for a tight, even trim. Light Part: At about half a pound, it is easy to handle during a swap. Spare on Hand: A backup blade keeps the machine cutting cleanly through a long harvest. Technical Specifications Specification Value Part number 777841 Type Straight replacement blade Quantity 1 blade Length 16 in Width 0.5 in Thickness 0.05 in Weight 0.5 lb Mounting Center hole Fits DL Wholesale Elite trimmer (777141) UPC 859097007849