PHOTOBIO X White Cable Harness, 16AWG 110-120V Plug, 5-15P, 10ft

5-15P 120V power cord for plug-and-play LED installs The PHOTOBIO X 120V harness routes 110-120V power to LED grow lights through a 10-foot 16AWG cable. A NEMA 5-15P plug ties the cable to standard residential and grow-room outlets without rewiring the panel. The IP-rated mini connector at the fixture end resists dust and the humidity swings common in flower rooms. Its white UV-resistant jacket bounces stray photons back to the canopy rather than absorbing them. 16AWG copper handles the lighter 120V draw without warming under a sustained lights-on cycle. 5-15P 120V power cord for the PHOTOBIO X fixture line Growers typically run the 120V harness in tents and small commercial rooms where a 240V branch isn't yet pulled. The cable drops in on Phantom PHOTOBIO CX, MX, T, and TX fixtures already configured for 110-120V branch circuits. Place the cable along the rear truss so the locking strain relief faces away from the canopy mist line. That keeps the connector dry during foliar sprays and avoids tugging when you pull a fixture for cleaning. The 10-foot run reaches across most 4x4 footprints without an extension, which keeps the breaker count honest. And the white jacket reads at a glance during a 3 a.m. fixture-down troubleshoot when the canopy lights are off. On smaller rooms you can chain a few low-draw LED bars per 15A circuit before reaching for the 240V harness sibling. That keeps the room growing while you plan the panel upgrade for 208-240V or 277V on the next install. Key Features NEMA 5-15P 120V plug: Standard 110-120V receptacle pattern that fits any household or grow-room outlet. 16AWG copper, 10-foot reach: Carries continuous 120V load across a single tent or rack without splicing. IP-rated mini connector: Sealed plug-and-play termination resists dust and runoff in flower rooms. White UV-resistant jacket: Bounces stray photons back to the canopy and stays visible at low light. Built for PHOTOBIO CX, MX, T, TX: Drop-in fit on the Phantom PHOTOBIO LED power lead family. Technical Specifications Specification Value Voltage 110-120V Plug Pattern NEMA 5-15P Conductor 16AWG copper Length 10 ft Connector Mini IP-rated plug-and-play Jacket White, UV-resistant Compatible Fixtures PHOTOBIO CX, MX, T, TX