Netafim Dripper Assy 6.6 GPH Orange/Grey Dripper, Black Tubing 36in. 25 Pack

6.6 GPH Dripper Assembly 36in for Grey Spray Stakes Plants at the far end of a drip run often get less water than the ones near the valve. Pots drift out of sync as pressure changes down the line. This assembly fixes that with an Orange/Grey Woodpecker pressure-compensating dripper that holds a steady 6.6 GPH from 10 to 60 PSI. A grower snaps the dripper onto the supply line and routes the 36-inch black micro-tubing to a container. A cap seats it at a matching grey spray stake. The 36-inch length suits closer bench and pot spacing where a longer lead would coil. Every emitter across the bench then puts down the same volume, whether it sits first or last on the line. Pressure-Compensating Drip Line with CNL Check Valve A built-in CNL check valve closes at about 7 PSI, so every dripper on the zone starts and stops together. Low points do not drain between cycles. That keeps the first pot from flooding while the last one drips, and it cuts the mess of after-run weeping under the benches. The 1/8-inch barbed outlet feeds the micro-tubing directly, and 120-mesh filtration upstream keeps the pressure-compensating path clear. Pre-matched color coding lets a grower pair the orange dripper to the grey stake at a glance during a large install. The result is uniform delivery a grower can set once and trust across the whole crop. Key Features 6.6 GPH pressure-compensating: Steady flow from 10 to 60 PSI 36 in micro-tubing: Black tube plus connection cap, for close spacing CNL check valve: Closes near 7 PSI, no low-point drainage 1/8 in barbed outlet: Feeds micro-tubing directly, 120-mesh filtration Color matched: Orange/Grey dripper pairs to the grey spray stake Technical Specifications Specification Detail Model 40201-002320 Flow Rate 6.6 GPH (25 LPH) Dripper Type PCJ Woodpecker, pressure-compensating, CNL Dripper Color Orange / Grey Pressure Range 10 to 60 PSI Check Valve CNL, closes near 7 PSI Tubing 36 in black micro-tubing with connection cap Outlet 1/8 in barbed Filtration 120 mesh (130 micron) recommended Pack Quantity 25 assemblies (stake sold separately)