Mobius M210 Mill Screens 4.0 mm (5/32?) perforated blending screen for the M210 Mill

Mobius M210 Mill Screen Specifications The 4.0 mm (5/32″) perforated screen sits between the included 1/8″ Medium and 3/16″ Coarse Standard options. It fills a gap. Operators get a discrete particle target when neither stock screen quite fits. Mobius rates the M210 at roughly 80% of milled material falling within 75–85% of screen aperture. For the 4 mm hole, expect the bulk of output between about 3.0 and 3.4 mm. That sizing range hits the practical sweet spot for blending dry flower lots before pre-roll machine feeding. It also preps biomass for hydrocarbon or ethanol extraction where consistent particle size drives yield. Perforated Blending Screen for Tool-Free Mill Setup As a perforated blending screen, this part is non-directional — install it in either orientation and the particle profile holds. Rasp screens in the M210 lineup have to be loaded a specific way; this one doesn't. The M210's tool-free screen change runs under a minute, with full cleaning prep in three. The 304 stainless steel construction takes pressure-wash cycles between strain runs without pitting or staining. That matters in GMP-ready facilities where sanitation logs get audited and any visible corrosion forces a part replacement. Pair this 4 mm screen with the 1/8″ Medium for a typical pre-roll workflow. Run coarse first for blending across lots, then drop to medium for the final feed grind. Key Features 4.0 mm (5/32″) Perforation: Drops particle output into the medium-coarse range, between the M210's stock 1/8″ Medium and 3/16″ Coarse Standard screens. 304 Stainless Steel: Food-grade construction handles full pressure-wash sanitation between runs without pitting or staining. Tool-Free Screen Swap: Goes in or out in under a minute; full cleaning prep cycle takes about three. Non-Directional Install: Perforated geometry means it can load in either orientation and produce the same grind profile, unlike rasp screens. GMP-Ready Construction: Built for sanitation-cycle compatibility in facilities running audited cleaning logs. Technical Specifications Specification Value Hole Style Perforated Hole Size 4.0 mm (5/32″) Material 304 Stainless Steel (food-grade) Compatibility Mobius M210 Rotary Mill Install Orientation Non-directional (either side up) Position in M210 Screen Lineup Between 1/8″ Medium (3.175 mm) and 3/16″ Coarse Standard (4.76 mm) Tool-Free Screen Swap Under 1 minute Cleaning Prep Time ~3 minutes Sanitation Pressure-wash compatible, GMP-ready Expected Particle Output ~3.0 – 3.4 mm (80% of mass within 75–85% of aperture) Typical Use Cases Pre-roll feed prep, extraction feedstock, lot-to-lot blending SKU 10-06-007243U-PK