Mobius M210 Mill Screens 12.7 mm (1/2?) perforated blending screen for the M210 Mill

Mobius M210 Mill Screen at 1/2″ Aperture The 12.7 mm (1/2″) perforated screen sits well above the M210's stock 1/4″ Coarse Blending screen. It's the largest aperture in the screen lineup. Output trends very coarse. Applying Mobius's 80% of material falling within 75–85% of aperture rule, the bulk of throughput lands somewhere around 9.5 to 10.8 mm. That's intentional. This screen isn't for finished product. It's for primary milling — taking whole flower or biomass down to a manageable particle size before a second pass through a finer screen. Some extraction methods also prefer a coarse, less-broken-up input. Perforated Blending Screen Built for Heavy-Throughput Runs As a perforated blending screen, the 1/2″ loads non-directional — either orientation produces the same particle profile, no specific load rule like the rasp screens. The high open area moves a lot of material through the chamber per minute. That's the point — with this screen in place, you're prioritizing throughput over fine particle control. The 304 stainless steel takes pressure-wash and CIP cleaning between strain runs without showing pitting or staining. That track record matters in GMP facilities where every visible defect on a contact surface gets logged and audited. Tool-free screen swap takes under a minute. Jumping from this 1/2″ for a coarse first pass to a 1/8″ Medium for the second adds almost no downtime to the run. Key Features 12.7 mm (1/2″) Aperture: The largest hole size in the M210 screen lineup; bulk output around 9.5–10.8 mm based on Mobius's 80%/75–85% rule. 304 Stainless Steel: Food-grade build that holds up to pressure-wash and CIP sanitation between runs. Tool-Free Swap: In or out in under a minute, which is what makes a coarse-first / fine-second milling workflow practical. Non-Directional Install: Perforated geometry loads either side up — no orientation rule like the M210 rasp screens. GMP-Ready Construction: Pressure-washable contact surface that holds visible-defect-free finish through repeated sanitation cycles. Technical Specifications Specification Value Hole Style Perforated Hole Size 12.7 mm (1/2″) Material 304 Stainless Steel (food-grade) Compatibility Mobius M210 Rotary Mill Install Orientation Non-directional (either side up) Position in M210 Screen Lineup Largest aperture — coarser than the stock 1/4″ Coarse Blending screen Tool-Free Screen Swap Under 1 minute Cleaning Prep Time ~3 minutes Sanitation Pressure-wash and CIP compatible, GMP-ready Expected Particle Output ~9.5 – 10.8 mm (80% of mass within 75–85% of aperture) Typical Use Cases Primary milling, coarse blending, high-throughput first pass, specific extraction methods SKU 10-06-004795U-PK