Milwaukee pH600 pH Tester. Pocket pH Pen, 0-14 pH, ±0.1 Accuracy

Milwaukee pH600 Pocket pH Pen This is a pocket-size digital pH pen that reads from 0.0 to 14.0 pH in 0.1 pH steps. Milwaukee Instruments rates its accuracy at ±0.1 pH at 25°C. Calibration is a single point at pH 7.01, set by turning a small trimmer on the back with a screwdriver. The large liquid crystal display shows the reading clearly while the pen sits in a sample. A pocket clip keeps it handy on a shirt or clipboard during a walk-through. Three 1.5V alkaline batteries power it for up to 700 hours of use. The pen measures 150 x 30 x 24 mm and weighs about 85 g. It works in surroundings from 5 to 50°C and up to 95% relative humidity. A protective cap covers the sensing probe between readings. Buffer sachets make calibration quick on the bench or in the grow room. It suits growers who want a quick, readable pH check without a bench meter. Keeping a Hydroponic pH Tester Reading True A hydroponic pH tester only helps if it is calibrated and stored well. Calibrate before the first use and then every week or two with fresh pH 7.01 buffer. Dip the pen to the maximum immersion line, let the reading settle, and turn the trimmer until the display reads 7.0. Always use fresh buffer, since a used sachet drifts and pulls the calibration with it. To take a reading, remove the cap, switch on and stir gently in the sample until the number stops moving. Rinse the probe with clean water after every reading. Store it with a few drops of storage solution in the cap. Distilled or deionized water should never be used for storage, as it pulls ions out of the glass. White crystals around the cap are normal and dissolve when rinsed. Large swings, around half a pH unit, usually point to a dry electrode, low batteries or a missed calibration. Mix nutrients first, then check pH last, since each additive shifts the reading. Key Features 0.0-14.0 pH Range: Covers the full scale, from acidic nutrient mixes to alkaline tap water. ±0.1 pH Accuracy: Reads to 0.1 pH resolution at 25°C. One-Point Calibration: Set at pH 7.01 with a small screwdriver and the rear trimmer. Large LCD: Easy to read while the pen sits in the sample. Long Battery Life: Three 1.5V alkaline cells last up to 700 hours. Pocket Clip and Cap: Clips to a pocket and protects the probe between readings. Technical Specifications Specification Value Model pH600 Item number 716642 Range 0.0 to 14.0 pH Resolution 0.1 pH Accuracy ±0.1 pH at 25°C (77°F) Calibration Manual, one point at pH 7.01 Operating environment 5 to 50°C (41 to 122°F), up to 95% RH Batteries 3 x 1.5V alkaline Battery life Up to 700 hours Dimensions 150 x 30 x 24 mm Weight 85 g UPC 810666001606