Growlink LINKs Din Rail Mounting Kit

Snapping LINKS Modules onto a Rail with the Growlink LINKS DIN Rail Kit The Growlink LINKS DIN Rail Kit converts any LINKS automation module from wall-mount install to standard 35mm DIN-rail mount. The kit snaps onto the back of the module and locks onto a TS35 / EN 60715 rail. That's the same profile used in commercial control panels worldwide. Installation is a single motion. Hook the top clip onto the rail's upper edge first. Then rotate the bottom of the module toward the rail until the spring-loaded lower clip snaps into place. Removal is the reverse, no fasteners required for either direction. Planning a Panel Build with the DIN Rail Mounting Kit Most growers reach for the DIN rail kit when consolidating LINKS modules inside a control enclosure outside the flower room. Growlink's own install guidance recommends mounting the HUB and downstream LINKs outside the growing environment to cut humidity exposure and make service access easier. The kit works with the LINKS HUB, relayLINK, digital lightLINK, valveLINK, quadLINK, lightLINK, canopyLINK, and the rest of the LINKs family. Modules ship with wall-mount hardware as the default. This DIN rail mounting kit is an optional accessory for the panel-build path. Pair it with a standard DIN rail enclosure to keep cable runs short and labeled across HUB-to-device connections. A clean rail layout also cuts troubleshooting time when a module needs swapped in a hurry. Compact craft grows and large multi-room facilities both benefit from the panel-mounted layout. Wall sprawl works when you only have one LINK. Once you have four or more LINKS, a DIN enclosure becomes the only way to keep cabling sane. Key Features Standard 35mm DIN Rail Fit: TS35 / EN 60715 profile — the most common rail in commercial control panels and electrical enclosures. Snap-On, No-Fastener Install: Hook the top clip, rotate the bottom in, snap — modules mount and unmount in seconds with no tools. Spring-Loaded Lower Clip: Holds the module flush against the rail and resists vibration in panel-mounted layouts. Works Across the LINKS Line: Fits the HUB, relayLINK, digital lightLINK, valveLINK, quadLINK, canopyLINK, and the rest of the LINKs family. Panel-Build Ready: Use inside a DIN rail enclosure to consolidate LINKS modules and keep cable runs short and labeled. Technical Specifications Specification Value Rail Standard 35mm DIN rail (TS35 / EN 60715, "top hat" profile) Install Type Snap-on, no-fastener (spring-loaded lower clip) Compatible Modules LINKS HUB, relayLINK, digital lightLINK, valveLINK, quadLINK, lightLINK, canopyLINK, and other LINKs family modules Default Module Hardware Wall-mount (DIN rail kit is an optional accessory) Typical Use DIN rail enclosure outside the flower room, consolidating multiple LINKs Removal Reverse install motion — no tools required