Chikamasa B-500SRF Curved Scissors. Fluorine-Coated Stainless Steel

Chikamasa B-500SRF Curved Blade With Sap-Resistant Coating Pick up a sticky branch at hour three of a wet trim and the difference shows right away. This orange pair carries the curved version of Chikamasa's B-500 blade, ground from high-quality Japanese stainless and finished with a fluorine coating. Resin that would glue bare steel shut sheds from that coating, so the blades keep opening cleanly between buds. The curve follows the shape of a flower rather than fighting it. Rolled along the outside of a nug, the 35 mm blade shaves sugar leaf close without stabbing into the calyx. Overall the frame runs 155 mm, compact enough to steer with two fingers and a thumb. Chikamasa rounds the outer edge of each blade, so the back of the curve brushes past finished flower without scarring it. The grip is elastomer resin over an internal steel core, soft in the palm but rigid where it counts. A stainless rivet holds tension at the pivot and resists rust, and a cushioned stop absorbs the shock of each closing stroke. Every pair is made in Japan by a company that has made shears in Sakai since 1910. Curved Trimming Scissors for Fast, Close Manicures A curved tip covers more surface per pass than a straight one, which is why so many hand trimmers default to it. It works for wet trim straight off the branch and for dry trim at the table after the hang. New pairs can arrive with a light film of oil on the blades, so wipe them down before the first cut. Build-up still happens on the coating, just more slowly, and a rag with isopropyl clears it without scraping. Keep a second pair in rotation so one can soak while the other works. The curve does give up some reach in tight spots. For digging out a leaf buried deep in a dense cola, the slanted B-500SLF gets there more easily. This model has no spring, so your fingers do the opening, which some trimmers find steadier over fine work. If hand fatigue is the bigger issue, the spring-loaded TP-500SRF pairs the same curved, coated blade with a torsion spring. Keep it on leaf and small stems, since woody branches will chip a fine edge faster than any amount of resin. Key Features Curved Stainless Blade: The curve follows the shape of each bud, so close manicuring takes fewer cuts and less wrist rotation. Fluorine Sap-Resistant Coating: Resin sheds from the coated blade, keeping the scissors opening cleanly through long trim sessions. Rounded Outer Edge: The outside of each blade is ground round to avoid scarring flower as the back of the curve brushes past. Steel-Core Elastomer Grip: Soft orange elastomer over a steel core keeps the pair comfortable yet rigid for hours of repetitive cutting. Cushioned Stop and Stainless Rivet: A soft stop softens each closing stroke, while a stainless rivet holds blade tension and resists rust. Technical Specifications Specification Value Model B-500SRF Blade High-quality Japanese stainless steel, fluorine coating Blade shape Curved Blade length 35 mm (1.4 in) Overall length 155 mm (6.1 in) Grip Elastomer resin with internal steel core, orange Spring None Place of origin Made in Japan