CenturionPro TableTop SS Stainless Steel Trimmer, 15 lbs/hr Wet

A Tabletop Bud Trimmer Built for Small Rooms Harvest day in a small room usually means a folding table, a stack of trays, and too few hands. The TableTop SS answers that with one 5.5 in tumbler that runs 24 in long and sits on a standard bench. Wet flower moves through at up to 15 lbs per hour, and dried material at roughly 3 lbs. A dial sets the reel anywhere between 2,500 and 20,000 cuts per minute. Slow it down for brittle dry buds. Open it up when the material is fresh and heavy with resin. The reel is nitrided rather than coated, so resin scrapes off instead of peeling the finish away. Its hopper is food-grade plastic, and the body and lid are electroless nickel plated aluminum. A 1 HP leaf collector pulls trim clear of the flower at 1,800 CFM. The whole unit weighs 55 lbs, which one person can move between rooms without a pallet jack. What the Stainless Steel Trimming Machine Changes on Cleaning Day Compliance work is where this machine earns its place. Bearings are food-grade stainless and sit inside a double sealed chamber, so nothing needs greasing between runs. That matters when an inspector asks what lubricant touches your flower. The 304 stainless and nickel plated surfaces wipe down with an approved sanitiser and do not pit. Growers running wet material learn to stop and clean every half hour or so. On this unit that job is a wipe and a reel pull, not a teardown. The triple-bag kief system drops in when you want to keep the trichome dust, and those bags are sold separately. Rail kits let a second or third machine line up end to end under one operator. Start on the bench, and add capacity later without replacing what you already own. Key Features Single Tumbler: 5.5 in diameter and 24 in long, electropolished stainless Speed Control: dial from 2,500 to 20,000 cuts per minute, standard on every SS model Throughput: up to 15 lbs of wet flower or 3 lbs of dry material per hour Construction: 304 stainless steel with electroless nickel plated aluminum body and lid Nitrided Reel: hardened rather than coated, so resin releases without stripping a finish Sealed Bearings: maintenance-free food-grade stainless inside a double sealed chamber Leaf Collector: 1 HP motor moving 1,800 CFM to keep trim away from finished flower Bench Footprint: 24 in x 10 in x 21 in and 55 lbs, movable by one person Technical Specifications Specification Value Processing Capability (up to, per hour) Wet: 15 lbs/hr · Dry: 3 lbs/hr Cuts Per Minute 2,500 to 20,000 Number of Tumblers 1 Tumbler Diameter 5.5 in Tumbler Length 24 in Dimensions (L x W x H) 24 in x 10 in x 21 in Weight 55 lbs Input Voltage 6 Amp at 110V (NA) · 3 Amp at 220V (EU/AUS) Leaf Collector 1 HP, 1,800 CFM Hopper Food Grade Plastic Body and Lid Electroless Nickel Plated Aluminum Cutting Reel Nitrided Reel Bearings Food Grade Stainless Steel Warranty 10 years machine · 2 years VSC