Autopilot CO2 Replacement Sensor w/15' Cable (for APC8200)

Autopilot CO2 Replacement Sensor for the APC8200 This replacement probe returns an APC8200 CO2 monitor and controller to accurate readings. It uses a 2-channel low-drift NDIR element that resists calibration drift over long runs. A 15 ft data cable lets you place the probe at canopy height while the controller stays at eye level. An integrated photocell recognizes lights-on and lights-off cycles. Placing a Remote CO2 Sensor in a Grow Room Mount the probe where the plants actually sit, not up near the ceiling where CO2 stratifies. The 15 ft lead reaches most tent and room layouts from a wall-mounted controller. Keep it clear of direct water and the generator exhaust plume. Once plugged in, the APC8200 reads from the new probe right away. Key Features 2-channel low-drift NDIR: Infrared sensing holds calibration over long grow cycles. 15 ft data cable: Places the probe at canopy height while the controller stays accessible. Integrated photocell: Recognizes lights-on and lights-off for smarter CO2 timing. Direct APC8200 fit: Plugs into the existing controller as a straight replacement. Remote placement: Reads CO2 where the plants sit, not where it pools near the ceiling. Technical Specifications Specification Value Sensor Type 2-channel low-drift NDIR Cable Length 15 ft Photocell Integrated (lights-on/off detection) Compatibility Autopilot APC8200 controller Function Replacement CO2 sensor probe