EZ-Clone Water Pump 450 (320 GPH) for 9, 16, and 32 Units

The EZ-Clone Water Pump 450 (320 GPH) for 9, 16, and 32 units goes well with each size of the cloning system to make sure that the manifolds get the right amount of water flow. These pumps are very good at using energy. Because their impellers are covered in plastic and they don't have motor seals that can leak or wear out, these pumps don't generate too much heat and last longer. Ultra Quiet Design: The sturdy and robust motor does not generate much noise, offering you a calm atmosphere. This submersible pump is ideal for use in hydroponic systems, water gardens, water gardens, and aquariums of a smaller size. It has many possible placement positions, so you may put it on an inclined or vertical surface, place it flat on its base, and manually spin it into whatever position you require. Adjustable Flow Rate: The power line is 6.5 feet long, which makes installation straightforward, and an adjustable knob gives you the ability to manage the water flow rate as well as the pressure; The maximum flow rate is 3,000 liters per hour (320 GPH); the wattage is 24W, and the voltage range is 110-120V. The maximum raised height is up to 6 feet. This water pump is simple to conceal due to its tiny size, and it does not require any tools for set up or disassembly. Additionally, it is very simple to clean. Water Pump Size: The dimensions of the pump, which are 7.1 inches long, 3.4 inches wide, and 5.9 inches high, make it easier to hide or disguise in the water due to its diminutive size. Since this clone water pump is so simple to operate, there is no requirement for any special equipment in order to detach it. It is simple to disassemble and clean, and all you need to do to drain the water quickly is connect it to an electrical outlet. Wide Range of Applications: This pump performs well and uses energy efficiently; it is also well suited for use in ponds, fountains, waterfalls, hydroponic systems, irrigation systems, and other similar applications. Temperatures range from 32 degrees to 104 degrees. This aquarium pump is submersible and must be fully immersed in water before turning on to avoid the aquarium pump burning out. We do not allow no-load running. It would reduce its lifespan and cause it to make loud noises while running in the air for an extended time. Please turn off the electricity when changing the water. If the water pump becomes clogged with debris such as dirt, waste, or sea salt, it must be cleansed with clean water before use. The temperature range for operation is 40–95°F. Because all pumps must be professionally water tested by our manufacturer before dispatch, please don't be concerned if the water pump you received has a small amount of water. The little bit of water that remains after expert water testing is a common occurrence. It's a new and ordinary pump. The inner shaft will be greased to guarantee good operation of the motor. If you are rearing delicate fish or aquatic plants, please keep them in different tanks for a short period before transferring them to fish tanks. Specifications: Brand EZ-Clone Enterprises Material Plastic Item Dimensions LxWxH 7.1 x 3.4 x 5.9 inches Power Source Corded Electric Item Weight 1.9 Pounds Maximum Flow Rate 5.33 Gallons Per Minute